26
4. Troubleshooting
4-1 Failure Display Codes
There is a error code and two kinds of error codes. Possible error codes
during use can be checked before service.
1. Press CLOCK pad.
2. Press a number 1, 2, 3, 4 pad.
3. Press the SET/START pad.
4. Press Delay start and number 0 pads at the same time for 2 seconds.
Error codes are displayed.
5. Press number 0 pad, the latest 5 error codes can be checked. But, if the oven
turns off, the stored error codes are deleted.
6. Press CLEAR/OFF pad to return to normal display mode.
Oven sensor error
Failure code CAUSE SOLUTION
E-27
oven sensor opened
(over 2950Ω)
1. Disconnect power. Open the back cover.
Disconnect sensor harness from control
Measure sensor resistance
:1080Ω at the room temperature
→ If there are any problems, replace oven
sensor.
2. If there is not any problem with oven sensor,
Please check whether there is a damaged
therminal or wire on harness.
3. Check resistance of oven sensor connector on
main PCB (Normal:2850Ω)
E-28
Oven sensor shorted.
(Under 930Ω)
4. Troubleshooting
Comments to this Manuals