Samsung SRG-148 User Manual download pdf (Page 6)

EN:

- Wipe with a damp sudsy cloth, then dry.

- For stubborn strains and for periodic waxing, use silicon wax.

- Wash entire compartments with a baking soda solution (two table-

spoon of baking soda to one quart of warm water). Rinse and dry.

- Wash compartment shelves, door shelves etc.

With either the baking soda solution or a mild detergent and warm

water. Rinse and dry.

-Wash with warm sudsy water,rinse throughly and dry.

-Insert all parts to proper location and set "Temperature control

to desired setting.

Exterior

Interior

Interior parts

Magnetic door gaskets

The finishing touch

The drip water tray

- To take out the drip water tray slide it out at a downward slant

Clean it once in a month.

- It it is not inserted properly, water will not evaporate or it will cause

unusual vibrating noises.

HOW TO CLEAN THE UNIT

INITIAL USING METHOD

EN:

1. Place all shelves, all kinds of vessels in their proper positions

which have been removed for transportation.

2. Clean refrigerator and parts to remove dust incurred during

shipping

3. Set cold control knob at "COLD" position and let refrigerator oper-

ate for one hour. Freezer compartment should get slightly chilled

and motor should run smoothly with no noise but soft hum.

4. Store food after the temperature in the refrigerator gets suffi-

ciently low. It takes a few hours after starting the refrigerator to

reach the proper temperature.

5. Your refrigerator is operated by a compressor which switchs "on

and off" to maintain the intemal temperature. When the compre-

ssor is new it requires running in for a period of up to 2 months.

During this period it may operate a little noiser than normal. This

is quite normal and does not represent a fault.

EN: FOLLOW THE STEPS BEFORE TO BEGIN OPERATION OF YOUR REFRIGERATOR.

1 2 3 4 5 6 7 8

No comments

Samsung SRG-148 User Manual Page 6