Samsung RSE8KPPS User Manual download pdf (Page 32)

INSTALLATION INSTRUCTIONS

INSTALLING THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line

1) Turn on the main water supply & shut-off valve of the water

supply line.

2) Run water through the dispenser until the water runs clear

(6~7 minutes). This will clean the water supply system and

clear air from the lines.

3) Additional flushing may be required in some households.

4) Open the refrigerator door and check if water leaks around

the water filter.

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.

NOTE

2) When you press the test button, the ice cube container is

filled with water from the water supply tap.

Check the amount of water (see the illustration below).

If the water level is too low,

the ice cubes will be small.

This is not a problem with the ice maker

but of the water pressure in

the pipe, and occurs frequently.

When this problem occurs, contact

the dealer service center to check the

amount of water supplied.

Check the amount of water supplied to the ice tray.

CHECK THE WATER

LEVEL

TEST BUTTON

TOO HIGH

OPTIMUM-

LEVEL

1) Lift up (

①

) and pull out (➁) the ice maker bucket in the freezer.

ICE MAKER

TOO LOW

WATER

ICE

Epel pjt IB-01453B-EN (0.1) 4/15/05 1:17 PM Page 31

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38

No comments

Samsung RSE8KPPS User Manual Page 32