Samsung RF25HMEDBSG User Manual download pdf

Before installation & calling service

ENGLISH

If you have further questions or your refrigerator has damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864).

1. Leveling & Door Alignment

•

For details, refer to “Leveling the

Refrigerator” in the User Manual.

Insert a ﬂat-blade screwdriver into a slot on •

the control lever, turn it clockwise or counter-

clockwise to level the refrigerator.

Control Lever

Flat-blade screw driver(-)

When the refrigerator is empty, adjust

the Leveling Leg Control by turning it

clockwise or counterclockwise with a

ﬂat head screwdriver until the Leveling

Legs contact to the ﬂoor.

This will allow better balance of the

Refrigerator when it is empty.

CAUTION

Door Alignment

Keep the snap rings out of reach of

children.

CAUTION

2. Automatic Ice Maker does not work

Allow your refrigerator to operate •

and cool down for 24 hours

(1 full day) before dispensing

large quantities of ice.

• To ﬁll the ice bucket to maximum capacity,

dispense a few cubes 8 and 16 hours after

installation.

•

If ICE OFF or Ice Maker Off is lit, the ice

maker will not make ice.

• To activate the ice maker, press ICE OFF or

the Ice Maker Off button on the control panel

so it is no longer lit.

3. Slow Ice Production

•

Check if the ice bucket is

completely inserted.

• Freezer temp may not be low

enough.

Set it to -2 °F (-19 °C) or lower.

4. Small ice cubes, ice cubes with

bubbles, or slow water dispensing

If the water ﬁlter is clogged, the ice maker may •

produce small ice cubes or ice cubes with

bubbles.

•

Replace the water ﬁlter cartridge with a new one.

5. Water ﬁlter replacement

After installation or when replacing the water

ﬁlter, dispense at least 1 gallon (2~3 minutes) of

water to remove trapped air from the water line.

Otherwise, water may drip from the dispenser

after you dispense water.

6. Water is not cool enough

The ﬁrst glass of water may not be cold enough •

because the stored water in the water tank has

not cooled completely.

Dispense several glasses of water until the

water is cool enough.

7. Water dispenser dripping

If the water line is not inserted into the coupler •

properly, air could penetrate into the water line

causing water to drip from the water dispenser.

• CAUTION : Insert the water line into the

coupler completely and slide in the clip at the

end of the coupler.

Red Clip

(1/4")

Dispenser

Door Tube

Cabinet

Tube

1. The Water Line must be fully inserted to the

center of the transparent coupler (Type A)

or the Guide Lines (Type B) to prevent water

leakage from the dispenser.

2. Insert the Clip A from the install pack and

conﬁrm that it holds the line ﬁrmly.

Center of Transparent coupler

The Guide Lines

Dispenser

clip A (1/4”) (6.35 mm)

Type A Type B

8. Fridge or freezer Compartments are

warm

Allow your refrigerator to operate and cool •

down for 24 hours (1 full day) to reach the

temperature you set.

Also, when you put room temperatu• re or warmer

food into your refrigerator, it may need an

additional 24 hours to reach the set temperature.

9. Moisture forms on outside/inside of

refrigerator

• Wipe off the condensation with a dry towel.

(This may occur during hot and humid weather.)

If the condensation appears on the doors, turn •

off the Energy Saving function.

If you open the doors frequently or for too long, •

it may cause moisture to form inside the fridge.

10. Noise Clicks, Pops, Cracks, Snaps

• You may hear these noises occasionally from

inside the refrigerator. This is normal. These

sounds occur when various items contract or

expand while temperatures inside the fridge are

changing, especially during defrosting. You may

also hear these noises when electronic devices,

including the ice maker, are operating.

11. Display

• Filter indicator : The ﬁlter Indicator turns red after

you use about 300 gallons of water (about 6

months of usage). Reset the indicator (it will be

Blue or off) after replacing the ﬁlter by holding the

ﬁlter reset button for 3 seconds.

• eht sserP : ffo ecI “Ice Off” or “Ice Maker Off”

button to turn the ice making function off.

• looC ing Off (Show Room) mo

de : If the Display

shows the “0F 0F” (or OFF) code, it means

that the Cooling Off function is activated and the

refrigerator is not cooling.

To cancel the Cooling Off mode, press the multiple

buttons on the display speciﬁed in the user’s manual.

12. Food stored in refrigerator is frozen

If food with too much moisture is sto• red near

the cooling vents, it may get frozen. Be sure to

keep moist food away from the cooling vents.

13. Moving the Refrigerator

W• hen moving the refrigerator, pull or push it

straight forward or backward.

Do not wiggle it from side to side.

DA99-04022A-14

Pull out the Convertible door to expose

the lower hinge .

Adjust the height by turning a philips

screwdriver (+) clockwise ( ) or

counterclockwise ( ).

Insert a philips screwdriver (+) into the shaft

of the lower hinge.

DOWN

1 2

Summary of Contents

Page 1 - Door Alignment

Before installation & calling serviceENGLISHIf you have further questions or your refrigerator has damaged accessory parts, contact us at 1-800-SA

Page 2 - Alignement des portes

ESPAÑOLFRANÇAIS1. Nivelación y alineación de la puerta• Para obtener más detalles, consulte “Nivelar el refrigerador” en el manual del usuario.• In

Comments to this Manuals

No comments

Samsung RF25HMEDBSG User Manual

Browse online or download User Manual for Ice cube makers Samsung RF25HMEDBSG. Samsung RF25HMEDBSG Black Stainless French Door Refrigerator with Twin Cooling Plus, 24.7 cu. Ft. Quick start guide

Summary of Contents

Comments to this Manuals

Related products and manuals for Ice cube makers Samsung RF25HMEDBSG