Samsung N640 User Manual Page 96

  • Download
  • Add to my manuals
  • Print
  • Page
    / 120
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 95
96 Troubleshooting
Some of the letter keys type numbers instead of the indicated letters.
Is the Num Lock light on? If so, the numeric keypad on the keyboard is active. To
return the keypad keys to typing letters, press <Num Lock>.
Battery power seems to run out faster than expected.
If you are running the computer from the battery rather than the power cord, make
sure that you set the Idle Mode field in System Setup to On. This setting enables
the microprocessor and the hard drive to slow down when the computer is not
busy.
You can also enable other power-saving options through System Setup. Set the
timeout times in the Standby Timeout and Rest Timeout fields to the shortest times
to ensure maximum power savings.
Certain software programs “hang” during operations when there is no
interaction with the keyboard or peripheral devices.
Your computer may be in standby or rest mode. Tap the touchpad to resume from
standby or press the power button to resume from rest.
A serial or parallel device attached to a serial or parallel port on the rear
panel of the system unit does not work properly.
Check the attached device. Is it turned on? Is the cable properly installed between
the device and the port? If you are using an operating system that is not plug and
play compliant, make sure the Plug & Play O/S field in System Setup is set to No.
Check to make sure that the port is enabled in System Setup.
A PC Card does not work correctly.
Make sure that the PC Card is inserted left side up in the PC Card slot. Check that
the card is inserted fully into the slot. If you are using a PC Card modem, check
the modem cable connections. For the Windows 98/ Me operating system, try
setting the Plug & Play OS field in System Setup to Yes to enable Windows 98/
Me to autosense an older PC Card. For the Windows NT operating system, make
sure Plug & Play O/S in System Setup is set to No.
The System Setup settings are not retained when you turn off the computer.
The CMOS battery inside the computer may need to be replaced. The CMOS
battery provides power to save the system BIOS information when the computer
is turned off. Normally, the CMOS battery lasts for several years. Do not attempt
to open the chassis and replace this battery yourself or your warranty is void. Have
an authorized the manufacturer’s service center replace the CMOS battery.
Page view 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 119 120

Comments to this Manuals

No comments