Samsung SA8000 SE User Manual download pdf (Page 5)

Chapter 5.Measurements and Calculations 5 - 5

Distance Measurement

▐ 2D Distance (Line) Measurement: measures the distance between two

points

The 2D Distance measurement function is available in all diagnosis modes. Its results are

shown in cm (or mm). A maximum of four sets of measurements can be displayed at one

time.

1. Press the Caliper button, and the measurement item appears on the left side of the

screen.

2. Select ‘2D Distance (Line)’ by pressing Flexible Soft button [1] Distance or by

pressing Change or Caliper button several times.

3. Use the Trackball to position the cursor on the start and end points of the area to be

measured. Press the Set button to fix the points.

4. Pressing the Change button before pressing Set button allows the measurement area

to be reset.

5. After position setup, distance and average are displayed on the screen.

6. A new cursor appears for a new measurement. If more than four distance

measurements are performed, the distance measurements are calculated in order.

The ratio of the first distance to the second, and the ratio of the third distance to the fourth

are calculated and displayed as percentages.

▐ 2D Distance (Trace) Measurement: measures a non-straight distance

between two points

This measurement function can be performed in all diagnosis modes. The results are

displayed in cm (or mm) on the screen. A maximum of four sets of measurements can be

displayed at one time.

1. Press the Caliper button, and the measurement item appears on the left side of the

screen.

2. Select ‘2D Distance (Trace)’ by pressing Flexible Soft button [1] Distance or by

pressing Change or Caliper button several times.

3. Use the Trackball to position the cursor on the start and end points. Press the Set

button to fix the points.

4. Pressing the Change button before pressing Set button allows the measurement

area to be reset. Pressing the Del on the keyboard before pressing Set button

erases part of the trace line.

5. After position setup, distance and average are displayed on the screen.

1 2 3 4 5 6 7 8 9 10 ... 54 55

No comments

Samsung SA8000 SE User Manual Page 5