41
ENGLISH
5. Check that you ared the pipe correctly.
Refer to below illustrations for correct and incorrect examples of ared pipe.
Uneven ThicknessCrackedDamaged SurfaceInclinedCorrect
• If foreign matters or burrs are not removed after cutting pipe, refrigerant gas may leak.
• If foreign matters enter inside the pipe, important interior parts of the unit may get damaged or product
eciency will be reduced. So, the direction of pipe should be downward during pipe cutting or aring.
CAUTION
Connecting the ared pipes
Check if the aring is properly done according to the standard size.
Align the center of the piping and tighten the are nut with your hands. Then, tighten the are nut with torque wrench in
a direction of the arrow indicated in below illustration.
Make sure to use ester oil to coat the are connection section.
Flare connection section Flare nut
Pipe
Monkey wrench
Torque wrench
Outer diameter Torque Flare dimension
Flare shape [mm(inch)]
mm inch N·m lbf·ft mm inch
6.35 1/4 14 ~ 18 10.3 ~ 13.3 8.7 ~ 9.1 0.34 ~ 0.36
90° ±2°
45° ±2°
R 0.4~0.8
(0.016~0.032)
9.52 3/8 34 ~ 42 25.1 ~ 31.0 12.8 ~ 13.2 0.50 ~ 0.52
12.7 1/2 49 ~ 61 36.1 ~ 45.0 16.2 ~ 16.6 0.64 ~ 0.65
15.88 5/8 68 ~ 82 50.2 ~ 60.5 19.3 ~ 19.7 0.76 ~ 0.78
• Blowing Nitrogen gas should be done when welding the pipe.
• Make sure to use the provided are nut.
• Make sure that there are no cracks or twisted part when you need to bend the pipe.
• Do not fasten the are nut with excessive strength.
• R-410A is a high pressure refrigerant and there is a risk of refrigerant leakage if the are connection is not coated
with ester oil. Therefore, apply ester oil to coat the are connection area.
CAUTION
DVM S ODU-SA_IM_05534A-01_EN.indd 41 2016-03-16 오후 3:00:59
Comments to this Manuals