Samsung LE32B551A6W User Manual Page 47

  • Download
  • Add to my manuals
  • Print
  • Page
    / 97
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 46

 
Others
Picture is not shown in full screen. Black bars on each side will be shown on HD channels when displaying upscaled SD
(4:3) contents.
Black bars on Top & Bottom will be shown on movies that have aspect ratios different
from your TV.
Adjust picture size option on your external device or TV to full screen.
Remote control does not work. Replace the remote control batteries with correct polarity (+ -).
Clean the transmission window located on the top of the remote.
Try pointing the remote directly at the TV from 5~6 feet away.
Can not control TV power or
volume with Cable/Set top box
remote control.
Program the Cable/Set top box remote control to operate the TV. Refer to Cable/Sat
user manual for SAMSUNG TV code.
‘Not Supported Mode’ message. Check the supported resolution of the TV and adjust the external device’s output
resolution accordingly. Refer to resolution settings in this manual.
Plastic smell from TV. This smell is normal and will dissipate over time.
TV  is
unavailable in the Self Diagnostic
Test menu.
This function is only available with digital channels with an Antenna (RF/Coax)
connection.
TV is tilted to right or left side. Remove the stand base from TV and reassemble.
Can not assemble stand base. Make sure TV is placed on flat surface. If can not remove screws from TV, please use
magnetized screw driver.
Channel menu is grey out.
(unavailable)
 menu is only available when TV source is selected.
Your settings are lost after 30
minutes or every time TV is
turned off.
If TV is in the  mode, it will reset audio and picture settings every 30
minutes. Please change from  mode to  mode in the 
 procedure. Press the  button to select  mode, go to 

E
.
Intermittent loss of audio or video. Check cable connections and reconnect.
Can be caused by using overly rigid or thick cables. Make sure the cables are flexible
enough for long term use. If wall mounting, we recommend using cables with 90
degree connectors.
You may see small particles if you
look closely at the edge of the
bezel surrounding the TV screen.
This is part of the product’s design and is not a defect.
‘Scramble signal’ or ‘Weak Signal/
No Signal’ with CAM CARD CI.
Check that CAM has CI Card installed into the common interface slot.
Pull out CAM from the TV and insert into the slot again.
When turned off and 45 minutes
later, TV is turned on itself.
It is normal, the TV operate OTA (Over The Air) function itself to upgrade firmware
downloaded during watching.
Recurrent picture/sound issue. Check and change signal/source.
This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there
may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
N
BN68-02315C-01L02.indb 45 2009-09-10 �� 9:15:50
Page view 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 96 97

Comments to this Manuals

No comments