iiLCD MONITORquick start guide2053NW / 2253NW
Q: There is no image on the screen. Is the power indicator on the monitor blinking at 1 secondintervals?A: The monitor is in PowerSaver mode.A: Press
A: Adjust the frequency properly by referring to the video card manual and the Preset TimingModes.(The maximum frequency per resolution may differ fro
A: Reboot the computer after installing the program for the first time. If a copy of the program isalready installed, remove it, reboot the computer,
A: Windows ME/2000:Set the resolution at the Control Panel → Display → Screen Saver.Set the function in the BIOS-SETUP of the computer. (Refer to the
IntroductionPackage Contents NotePlease make sure the following items are included with your monitor.If any items are missing, contact your dealer.Con
Your MonitorInitial SettingsSelect the language using the up or down key.The displayed content will disappear after 40 seconds.Turn the Power button o
NoteYou can configure the customized key for a required function via Setup > Cus-tomized Key.Brightness button [ ]When OSD is not on the screen, p
NoteSee Connecting Cables for further information regarding cable connections.Introduction11
ConnectionsConnecting Cables Connect the power cord for your monitor to the power port on the back of the monitor.Plug the power cord for the monitor
Monitor and BottomAttaching a BaseThis monitor accepts a 100 mm x 100 mm VESA-compliant mounting interface pad.A. MonitorB. Mounting interface pad (So
TroubleshootingSelf-Test Feature Check NoteYour monitor provides a self test feature that allows you to check whether your monitor is functioningprope
noisy, and video mode not supported, etc. In this case, first check the source of the problem, and thencontact the Service Center or your dealer.Judgi
Comments to this Manuals