Samsung WF438AAR-XAA User Manual download pdf (Page 11)

Installing your washer _11

STEP 2

Removing the Shipping Bolts

Before using your Washer, you must remove the four shipping

bolts from the back of the unit.

1. Loosen all the bolts with the supplied wrench.

2. Slide the bolt and spacer up and remove the bolt with the

spacer through the hole in the rear wall of your washer.

Repeat for each bolt.

3. Fill the holes with the supplied Bolt Hole Covers (See page 7).

4. Keep the shipping bolts and spacers for future use.

STEP 3

Selecting a Location

Before you install your washer, make sure the location:

• Has a hard, level surface

• Is away from direct sunlight

• Has adequate ventilation

• Will not freeze (below 32°F or 0°C)

• Is away from heat sources such as oil or gas

• Has enough slack for the power cord.

• Doesn’t have any carpeting that will obstruct ventilation openings.

STEP 4

Installing your Washer

1. Place the drain hose in the drain facility. Be

sure an airtight connection is NOT made

between the drain hose and the standpipe.

The standpipe must be at least 18 in or 46

cm high.

Caution must always be exercised to

avoid collapsing or damaging the drain

hose. For best results, the drain hose

should not be restricted in any way – by

elbows, couplings, or excessive lengths.

For situations where the drain hose

cannot be conveniently elevated to at

least 18 in or 46 cm, the drain hose must

be supported.

2. Insert new rubber washer (supplied) into each end of the

inlet hoses. Firmly seat the washers in the couplings.

01 Installing your washer

96” Max

18” Min

96” Max

18” Min

Hose

retainer

Tie strap

Laundry tub Stand pipe

WF448AAW-02535A-02_EN.indd 11 2008-05-06 ¿ÀÈÄ 2:23:14

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

Comments to this Manuals

No comments

Samsung WF438AAR-XAA User Manual Page 11

Comments to this Manuals

Related products and manuals for Washers Samsung WF438AAR-XAA