Samsung RF23HTEDBSR Manual download pdf (Page 28)

English - 28

Removing any residual matter inside the

water supply line after installing the water

ﬁ lter.

1. Turn ON the water supply if you turned it off

when you installed the water ﬁ lter.

2. Run water through the dispenser until the water

runs clear (approx. 6 to 7 minutes).

This will clean the water supply system and

remove air from the lines.

3. Additional ﬂ ushing may be required in some

households.

4. Open the Refrigerator door and make sure

there are no water leaks coming from the water

ﬁ lter.

Be sure to ﬂ ush the dispenser thoroughly,

otherwise water may drip from the

dispenser.

This means that there is still air in the line.

Reverse Osmosis Water Supply

IMPORTANT:

The pressure of the water supply coming out of a

reverse osmosis system going to the water inlet

valve of the refrigerator needs to be between 35

and 120psi. (241 and 827kPa)

If a reverse osmosis water ﬁ ltration system is

connected to your cold water supply, the water

pressure to the reverse osmosis system needs to

be a minimum of 40 to 60psi. (276 to 414kPa)

If the water pressure to the reverse osmosis

system is less than 40 to 60psi (276 to 414kPa):

• Check if the sediment ﬁ lter in the reverse

osmosis system is blocked.

Replace the ﬁ lter if necessary.

• Allow the storage tank on the reverse osmosis

system to reﬁ ll after heavy usage.

• If your refrigerator has a water ﬁ lter, it may

further reduce the water pressure when used

in conjunction with a reverse osmosis system.

Remove the water ﬁ lter.

If you have questions about your water pressure,

call a licensed, qualiﬁ ed plumber.

DA68-02954B-04.indb 28DA68-02954B-04.indb 28 2015. 4. 24.  3:062015. 4. 24.  3:06

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 143 144

Comments to this Manuals

No comments

Samsung RF23HTEDBSR Manual Page 28

Comments to this Manuals

Related products and manuals for Fridges Samsung RF23HTEDBSR