
English - 24
MAKING MINOR ADJUSTMENTS
BETWEEN OUT DOOR AND IN
DOOR
After raising the out door, insert the supplied SHIM
HINGE MIDDLE in the gap between the OUT
DOOR and the HINGE-SHAFT.
SHIM HINGE MIDDLE are enclosed with
the refrigerator.
The thickness of RING is 0.04” (1mm).
Keep the Rings out of the reach of children
and make sure that children do not play
with them or put them into their mouths.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize the water or destroy
microorganisms. You may need to purchase a
water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125psi (138 ~ 862kPa) is
required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
CAUTION
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and a ¼” compression nut.
The new hose-sets supplied with the
appliance are to be used and that old
hose-sets should not be reused.
Connecting to the water supply line
1. First, shut o the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut o valve.
Pipe clamp
Cold water line
Shut o valve
3. Connect the water line installation kit to the shut
o valve.
Shut o valve
Pipe clamp
Cold water line
Water line installation kit
DA68-02954C (EN)-04.indd 24 15. 5. 26. �� 9:30
Comments to this Manuals