Samsung RS267LABB Specifications download pdf (Page 77)

11. CIRCUIT DESCRIPTIONS

-4) Door S/W Sensing Circuit

11-5) Temperature Sensing Circuit

1) The terminals, ② and ⑥ of the connector (CN30) are grounded, and DC5V (Vcc) is supplied to the terminals, ⑤ and

⑥ through the resistors, R404 and R403 for the freezer and the refrigerator door, respectively.

2) The micro-processor senses the door’s open and close based on engaged voltages, “Low(0V)” and “High(5V),”

respectively.

Note) The door switch always should be checked when the evaporator fan is not running while the door is closed.

Terminal

Operation Volt(state)

Freezer

DOOR CLOSE

DOOR OPEN

0V (LOW)

5V (HIGH)

Ref.

DOOR CLOSE

DOOR OPEN

0V (LOW)

5V (HIGH)

# of t

erminal in MICOM Remark

PIN #49 (F-SENSOR)

PIN #50 (F-DEF-SENSOR)

PIN #52 (R-SENSOR)

PIN #53 (R-DEF-SENSOR)

PIN #56 (EXT-SENSOR)

Micom

terminal

voltage may

change

according to

temp.

1) A thermistor with a negative temperature coefficient (NTC) is used for a temperature sensor.

2) Resistors, R 306 ∼ R310 and capacitors, C 301 ∼ C 305 are used for a noise protection purpose.

3) For the F-sensor, the input voltage into the micro processor (MICOM), VF is calculated by (Rth x Vcc)/(R303+ Rth),

where Rth is a corresponding resistance to the thermistor’s output (See Ref. 6 in Appendix).

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 91 92

No comments

Samsung RS267LABB Specifications Page 77