12_Setting up
Removing the refrigerator doors
SETTING UP YOUR SIDE-BY-SIDE REFRIGERATOR
If your entrance won’t allow the refrigerator to pass easily through it, you can
remove the refrigerator doors.
Removing the front cover of leg
•
First, open the freezer and fridge doors;
•
Then rotate three screws at the front cover of leg
anti-clockwise to remove the front cover.
Removing and installing the freezer door
A few things to mention first.
•
Make sure that you lift the door straight up
so the hinges are not bent or broken.
•
Be careful not to pinch the wire harness on
the door.
•
Place doors on a protected surface to prevent scratching or damage.
1. Remove the upper hinge cover using a screwdriver, and then disconnect
the wires by gently pulling them apart .
2. Remove hinge screws and the
ground wire screw by turning
anticlockwise, and take off the upper
hinge . Be careful that the door does
not fall on you as you are removing it.
3. Remove the door from the lower hinge
by carefully lifting the door straight
up .
4. Remove the lower hinge with a hex wrench.
5. After the refrigerator is placed to the specified position, install the freezer door
in the reverse order as above.
Comments to this Manuals