English - 13
03 OVEN USE
CHECKING IF YOUR OVEN IS OPERATING
CORRECTLY
The following simple procedure enables you to confirm your oven is working correctly at
all times.
Open the oven door by pushing the push button on the bottom side of the control panel.
Place a glass of water on the turntable. Then, close the door.
1. Press the Number buttons to enter an operating time of
4to 5 minutes.
2. Press the Start button.
Result: The oven heats the water for 4 or 5 minutes. The
water should then be boiling.
1) When cooking has finished the oven beeps
4 times.
2) The end reminder signal will beep 1 time
(once every minute).
3) The current time is displayed again.
The oven must be plugged into an appropriate wall socket. The turntable must be
in position in the oven. If a power level other than the maximum is used, the water
takes longer to boil.
SETTING THE TIME
Your microwave oven has an inbuilt clock. When power is supplied, “:0”, “88:88” or
“12:00” is automatically displayed on the display.
You must set the clock:
•
When you first install your microwave oven
•
After a power failure
Do not forget to reset the clock when you switch to and from summer and winter
time.
1. To set the time.
Press the Clock button once.
2. Use the Number buttons to enter the current time. You
must press at least three numbers to set the clock. If the
current time is 5:00 enter, 5, 0, 0.
3. Press the Start button again. A colon will blink, indicating
that the time is set.
SWITCHING THE TIME NOTATION
You can change the time notation (12H/24H). 12H is the default.
1. Press the hidden button (Clock + the Number “0” button).
Then, press the Number button corresponding to your
choice.
Number Notation
1 12 hours
2 24 hours
2. Press the Start button.
SETTING POWER LEVELS
Your microwave allows you to set up to two dierent stages of
cooking, each with its own time length and power level. The
MWO Power level button lets you control the heating intensity
from Warm (1) to High (10).
ONE-STAGE COOKING
For simple one-stage cooking, you only need to set a cooking time. The power level is
automatically set to High. If you want to set the power to any other level, you must set it
using the MWO Power level button.
1. Use the Number buttons to set a cooking time. You can set
a time from one second to 99 minutes, 99 seconds. To set a
time over one minute, enter the seconds too. For example,
to set 20 minutes, enter 2, 0, 0, 0.
2. If you want to set the power level to something other than
High, press the MWO Power level button, then use the
Number buttons to enter a power level.
Power Levels
0 = PL:0 (Deodorization) 6 = PL:60 (Simmer)
1 = PL:10 (Warm) 7 = PL:70 (Medium high)
2 = PL:20 (Defrost) 8 = PL:80 (Reheat)
3 = PL:30 (Low) 9 = PL:90 (Sauté)
4 = PL:40 (Medium low) 10 = PL:Hi (High)
5 = PL:50 (Medium)
3. Press the Start button to begin cooking. If you want to
change the power level, press the Stop/Cancel button
before you press the Start button, and repeat Steps 1 and
2 above.
Some recipes require dierent stages of cooking at dierent temperatures. You can set
multiple stages of cooking with your microwave.
MG11H2020CT_AA_DE68-04270A-00_EN.indd 13 2014-06-16 �� 4:21:55
Comments to this Manuals