Samsung DCS 400si User's Guide download pdf (Page 8)

SYSTEM ADMINISTRATOR

PROGRAMMING

CUSTOMER LEVEL ACCESS

Before any customer programs can be accessed, you must first open system

programming using the passcode you have been assigned. You must use an

LCD 12B or LCD 24B keyset. Should it become necessary to change this

passcode, see your service company.

• While on-hook, press TRSF and then dial 200. Your display shows [EN-

ABLE CUS. PROG. PASSCODE].

• Dial the four digit passcode. The display shows [ENABLE CUS. PROG. -

DISABLE].

• Dial 1 to enable. The display shows [ENABLE CUS. PROG - ENABLE].

• Press TRSF. The keyset returns to its idle condition.

• Press TRSF and then dial the three digit program code you want to ac-

cess. Follow the instructions for that program.

NOTE: You must begin programming within 30 seconds. Once you are in pro-

gramming, any delay of more than 30 seconds between key strokes will cause

the system to automatically close programming.

CHANGING FEATURE PASSCODE

You can change individual feature passcodes. This program is used to change

the passcodes for several features. These features are the following: RING PLAN

SERVICE, DISA ALARM, ALARM CLEAR, and AA RECORD. Note: Each

passcode is four digits long. Each digit can be 0 to 9.

PROGRAM KEYS

UP & DOWN - Select the extension number.

HOLD - Press to reset the passcode to default settings.

Open customer programming and follow the instructions below.

ACTION DISPLAY

1. Press TRSF and then dial 202 CHANGE PASSCODE

Display shows RING PLAN: 0000

2. Use the UP and DOWN keys to scroll CHANGE PASSCODE

through the different options and press DISA ALARM:5678

the right soft keys.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

No comments

Samsung DCS 400si User's Guide Page 8