28_ operating
USING THE VACUUM CLEANING ROBOT
Starting/Stopping Cleaning
You can run or stop all vacuum cleaning robot functions.
Each vacuum cleaning robot function only runs when the
■
Power Switch is turned on.
When the vacuum cleaning robot is operating, press the (
■
)
button to cancel the operation and select a function.
Turning the power on or off
Turning the power on
Main unit: Press the ( -
) button.
Turning the power off
Remote control: Press the - [Power] button.
Main unit: Press and hold the ( -
) button down for 3 seconds.
If no key is pressed for approximately 1 minute after turning the power
❈
on, the power is automatically cut to prevent the battery discharging.
To turn the power on again, press and hold the power (Start/Stop)
button on the main body.
Starting or stopping cleaning
Starting
Remote control : Press the Auto, Spot, Max, Manual button. -
Main unit : Select Auto, Spot, Max mode by using the ( -
) button
and then pressing the (
) button.
When cleaning begins, the vacuum cleaning robot starts to move. -
Pressing the (
❈
) button without selecting cleaning mode starts
to perform the Auto mode cleaning.
Stopping
To stop, press the ( -
) remote control or main unit button.
When cleaning is stopped, the vacuum cleaning robot stops. -
Using the main unit
buttons
Using the remote
control
DJ68-00632F.indb 28DJ68-00632F.indb 28 2012.1.19 3:35:27 PM2012.1.19 3:35:27 PM
Comments to this Manuals