Samsung WD7101CKW User Manual download pdf (Page 7)

Installing the washing machine _7

SELECTING A LOCATION

Before you install the washing machine, select a location with the following characteristics:

• A hard, level surface (if the surface is uneven, see “Adjusting the leveling feet,” below)

• Away from direct sunlight.

• Adequate ventilation

• Room temperature that will not fall below 0˚C

• Away from sources of heat such as coal or gas

Make sure that the washing machine does not stand on its power cord.

Ventilation openings must not be obstructed by carpeting when the washing machine is installed

on a carpeted floor.

ADJUSTING THE LEVELING FEET

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the

feet):

1. Loosen the leg bolt by turning it with your hand until it is at

the desired height.

2. Tighten the locking nut by turning it with a (-) screwdriver.

If the washer is placed on an uneven or weak surface, noise or

vibration occurs.

(Only a l degrees angle is allowed.)

REMOVING THE SHIPPING BOLTS

Before using the washing machine, you must remove the four

shipping bolts from the back of the unit. To remove the bolts:

1. Loosen all bolts with the wrench before removing them.

2. Take each bolt head and pull it through the wide part of the

hole.

Repeat for each bolt.

3. Fill the holes with the supplied plastic covers.

4. Keep the shipping bolts for future use.

01 Installing the washing machine

WD7101CKW-02502E-01_EN BASIC.indd 7 2007-11-09 ¿ÀÈÄ 3:21:40

1 2 3 4 5 6 7 8 9 10 11 12 ... 111 112

No comments

Samsung WD7101CKW User Manual Page 7