Samsung WF220ANW/XAA User Manual download pdf

Fast Track Troubleshooting

Model: WF220ANW/XAA

Publication # tsWF220 Revision Date 9/25/2011

Quick Test Mode:

To enter press Spin, Soil, & Power

simultaneously with the power off.

1. All LED’s light up and the washer beeps as it

enters the Quick Test Mode.

2. The unit displays the software version.

3. After the displaying the software version, turn

Jog dial CCW until version disappears.

Press Spin to test Door Lock/Unlock circuit.

Press Temp Key (with door locked) to cycle through

the Water Valves circuit test in this order: Cold Main,

Bleach, Hot, then off.

Press Soil Key to test the Heater

Press Signal Key to test the Pump

Service Mode:

This mode allows more detailed operation tests

and troubleshooting, to enter press Signal & Extra

Rinse simultaneously with the power on.

While in Service Mode (the Service Mode can be entered

while the unit is in a wash cycle) the following tests can

be performed:

Quick Spin Test = Delay Start & Temp: This accelerates

the drum motor from 0 to maximum RPM over a few min-

utes. Press the Start/Pause button during the test to hold

its spinning speed up to 10 min. before going back to Quick

Spin Test Mode, return to spin with Delay Start & Temp.

Cycle Count = Press the Signal button to see how many

times the unit was used

Soft Ware # = Press the Soil Level button to see the software

version information

Fast Time Down = Press the Temp button to enter and Temp

to advance to the next cycle

Fault Code Test = Press the Spin button to view the stored

fault codes – then turn Dial to view error codes (Push Start/

Pause while the code is displayed to view the number of cy-

cles since the error occurred, push Start/Pause again to get

back to faults)

Peripheral (Main PCB) input Tests, enter Service Mode &

press Extra Rinse.

1. Turn the Dial CCW to Normal, Temperature will be dis-

played in Celsius.

2. Turn the Dial CCW to Heavy Duty, Temperature will be dis-

played in Fahrenheit .

3. Turn the Dial CCW to Perm Press, The door switch status

will be displayed (CL if Closed, OP if Open).

4. Turn the Dial CCW to Sanitize, The door lock Switch status

will be displayed (UL if unlocked, LO if locked).

Water Frequency/Water Sensor Testing Select a cycle &

start the washer, enter Service Mode & press Extra Rinse.

Turn the Dial so that the Rinse+Spin LED is turned on. Next,

press the Start/Pause Key. The Water Frequency will be dis-

played. The frequency will change as the unit fills.

IMPORTANT SAFETY NOTICE – “For Technicians Only” This service data sheet is

intended for use by persons having electrical, electronic, and mechanical experience

and knowledge at a level generally considered acceptable in the appliance repair trade.

Any attempt to repair a major appliance may result in personal injury and property

damage. The manufacturer or seller cannot be responsible, nor assume any liability for

injury or damage of any kind arising from the use of this data sheet.

Spin Only option:

Power on, Press and hold Spin until display changes.

Press Spin to select spin time.

Press Start/Pause to start cycle, Normal Cycle 10/12

minutes, Heavy Duty Cycle 11/13 minutes, Delicate

Cycle 8 minute. Spin speed varies with cycle.

EEPROM Clear Check

Power off, Press Delay Start, and Power Key at the

same time. Good = Goo Fail = FAI

All memory will be cleared, including Fault Codes

This should be done when a new Main PCB is installed

Fabric Softener Dispenser Test:

Start Rinse and Spin Cycle. After fill is completed

remove detergent drawer, place towel below opening

and within 3 minutes the dispenser will activate

Please Note: There are

Serial # changes on this

model, verify you are order-

ing the correct parts for the

Serial # you are servicing

by reviewing Bulletins.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Fast Track Troubleshooting

Fast Track Troubleshooting Model: WF220ANW/XAA Publication # tsWF220 Revision Date 9/25/2011 Quick Test Mode: To enter press Spin, Soil, & Powe

Page 2 - RY1 RY2

RY1 RY2

Page 3

Washer Connector Checks WF220 CN2 1 AC Pwr (Wht) 3 AC Pwr L (Blu) Water Level Sensor Check Test 1 Test 2 Voltage: Connector CN 3 Pin 4 (Pink) and CN

Page 4 - ∞Ω Door Open

Door Lock Check Test 1 Test 2 Connector CN Pin 3 (Blk) and RY1 Pin 2 (Blue) When Door is Unlocked 6VAC When Door is Locked 0VAC N/A A/C Power Ch

Page 5

Error Type Error Code Details Drain Error nD 1 Check for Foreign material entering the pump or hoses. Check to make

Page 6

When installing a washer and dryer on the first, or second floor, do not exceed this leg adjustment height for stability. Error Type Error Code D

Page 7 - SUPPORT INFORMATION

Water valve connections for the Detergent Drawer Items Packed With Washer BOLT-SPANER (10-13mm Wrench) DC60-40146A ASSY HOSE WATER Cold DC97-15648A

Page 8

No Power or Dead Unit Troubleshooting

Samsung WF220ANW/XAA User Manual

Browse online or download User Manual for Washing machines Samsung WF220ANW/XAA. WF220 Fast track R5 - P.C. Richard & Son

Summary of Contents

More documents for Washing machines Samsung WF220ANW/XAA

Comments to this Manuals

Samsung WF220ANW/XAA User Manual

Browse online or download User Manual for Washing machines Samsung WF220ANW/XAA. WF220 Fast track R5 - P.C. Richard & Son

Summary of Contents

More documents for Washing machines Samsung WF220ANW/XAA

Comments to this Manuals

Related products and manuals for Washing machines Samsung WF220ANW/XAA