4-14
Operation Manual
Starting & Ending M Mode
Press the M button on the control panel. Press this button again. M Mode will be terminated and the
mode switched to 2D.
M Mode Screen
M Line
Use the trackball on the control panel to move the line to the right or left. The M Line indicates
the relative position of the M Mode image in the 2D image. Therefore, you can move the M Line to
change the observation area.
M Mode Soft Menu
NOTE: The soft menu referred in this manual can be accessed from default settings at Utility >
Menu Edit.
The soft menu in M mode consists of the following:
1 2 3 4 5 6
Display Format Speed Loop Size Chroma Map Type Power M Edge Enhance
Negative Chroma Map Anatomical M
Display Format
Used to congure M image and 2D image layout. Rotate the soft menu’s dial-button [1] and choose
between Top/Bottom and Side By Side.
X
Top/Bottom: Places the M image on top of the 2D image.
X
Side By Side: The 2D image is displayed on the left and the M image on the right.
Speed
Used to adjust the M image speed. Select 60Hz, 120Hz, 180z, 240Hz, 300Hz or 360Hz by rotating the
soft menu’s dial-button [2].
Comments to this Manuals