Stretch out the speaker cable and get it through as shown.
NOTE
When installing the front and surround speakers, match the label colour
of the stand with the cable colour of the speaker.
1.
✎
`
Installing the Speakers on the Tallboy Stand
Stand Pole
1
Stand Base
Tighten up the screws (large) (3.5x18, x3) as shown.
3.
3
Fit the stand pole into the stand base.
(if they do not fit with each other, the stand may get tilted from
an improper installation.)
2.
Stand Pole
2
Stand Base
CAUTION
When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
!
`
Comments to this Manuals