Samsung CHT-420 User Manual download pdf (Page 26)

You can customize the sound to best fit the specific acoustics of the

room by adding a delay to the sound from the center and surround

speakers.

The delay time is initially set to 0 ms.

◆ You can enjoy the best sound during 5.1 channel surround

playback if the distance between you and each speaker is the

same. You can adjust the delay time for the center and surround

speakers according to the placement of the speakers in the

room.

◆ For the center speaker

If the distance of Dc is equal to or longer than the distance of

Df, set the delay time to 0 ms.

Otherwise, change the value according to the table.

(A)=Df-Dc

◆ For the surround speakers

If the distance of Df is equal to the distance of Ds, set the delay

time to

0 ms.

Otherwise, change the value according to the table shown on

the right.

(B)=Df-Ds

1 Center speaker

Place the speaker directly over or under the TV. But, ideally, the

center speaker should be positioned with the top surface flush

with the front speakers..

2 Front speakers

Place the front speakers so that their tweeters (high-range) are

aligned at about the same height as ear level and at a horizontal

angle of 45° with respect to the prime listening position.

3 Surround speakers

Place these speakers behind your listening position, facing slightly

inwards, about 2 to 3 feet (60 to 90 cm) above ear level.

If there isn't enough space behind the listening position (i.e., close

to the wall), place the surround speakers at either side with their

front surfaces facing each other.

4 Subwoofer

The position or orientation of the subwoofer is not as critical.

Place it anywhere you want.

Speaker setup

Volume light

Speaker Volume Control

1 Open “MENU”

With the DVD in stop mode, press the MENU button.

2 Select “Install”

Using the up/down and left/right buttons, move the selection cursor

to “Installation”, then press ENTER to select.

3 Select “Volume light”

Move the selection arrow to “Volume light”, then press right to

select from the following options.

• Auto - Volume light (light surrounding main unit volume control)

will be turned off automatically.

• On - Volume light will be bright all the time.

1 AMP Volume Control

• Connect the speakers to the speaker jack on the rear.

• The volume can be adjusted from level 20.

• When you turn the power ON, if the last volume level was over

20, the volume will be set to 20, and if it was under 20, the

volume will be set to that level.

2 Headphone Volume Control

• You can adjust the volume by connecting the headphone to the

Headphone JACK on the front panel.

• The volume can be adjusted from level 31, and the AMP SPEAKER

will be muted.

• The LINE OUT AUDIO will be output continuously while the

Headphone is connected.

1 Open “MENU”

With the DVD in stop mode, press the MENU button.

2 Select “DVD”

Using the up/down and left/right buttons, move the selection cursor

to “DVD Setup”, then press ENTER to select.

3 Select “Audio Options”

Move the selection bar to “Audio Options”, then press ENTER to

options.

Setting the delay time

Ideal speaker placement

MAIN MENU

Installation

RETURN

❷

ENTER

Program Clock Install Exit

DVD VCR Options Language

Install

INSTALLATION

Channel setup

❿

Volume light : [Auto]

RETURN

❷  

➛❿

Auto

OPEN/CLOSE

PROG DVD VCR FM/AM INPUT

EJECT

PHONES

REC S.MODE S.EFFECT

VOL

Ideal speaker

placement

Ideal speaker placement

(A) Distance (feet/inches) Value (ms)

1 feet 2 inches 1

2 feet 3 inches 2

3 feet 4 inches 3

4 feet 6 inches 4

5 feet 7 inches 5

(B) Distance (feet/inches) Value (ms)

3 feet 4 inches 3

6 feet 8 inches 6

10 feet 1 inches 9

13 feet 5 inches 12

16 feet 9 inches 15

1 2 ... 21 22 23 24 25 26 27 28 29 30 31

Comments to this Manuals

No comments

Samsung CHT-420 User Manual Page 26

Comments to this Manuals

Related products and manuals for DVD players Samsung CHT-420