Samsung SV-DVD640 User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 47
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
ENG-17
The programme number or times flash
You wish to modify the programme
4 If the programme and times are correct, press the
RETURN button.
5 Press the STANDBY/ON button to activate the
timer.
6 Refer to page 19~20 if you wish to:
Check that your DVD-VCR has been
programmed correctly
Cancel a preset recording
The numbers next to each TV programme listing
are ShowView code numbers, which allow you to
programme your videorecorder instantly with the
remote control. Tap in the ShowView code for the
programme you wish to record.
ShowView is a trademark of Gemstar Development
Corporation. The ShowView system is manufactured under
licence from Gemstar Development Corporation.
Using the ShowView Feature
3 Press the OK button.
Result: The information concerning the programme
is displayed.
When using the ShowView function for the
first time with stored stations, the programme
number flashes. This one time, you must enter
the station number manually by pressing the
or
buttons. Refer to the following page if:
Before presetting your DVD-VCR:
Switch on both the television and your DVD-VCR
Check that the date and time are correct
Insert the cassette on which the programme is to
be recorded (safety tab intact)
Up to six programmes can be preset.
1 To enter a ShowView, press the TIMER button.
Press the
or
and OK or
buttons to select
ShowView
Result: A message is displayed to allow you to
enter the ShowView code.
If all six programmes have been set, the
message Timer is full is displayed. Refer to
page 22 if you wish to cancel a preset
recording.
2 Press the numeric buttons to enter the code
opposite the programme that you wish to record in
your television magazine.
If you wish to correct the ShowView code that
you are entering:
Press the
button until the digit to be
corrected is cleared
Enter the correct digit
Standard
ShowView
Timer Method
ShowView
Code
Code : 0 - 9
Correct :
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 46 47

Comments to this Manuals

No comments