Samsung RSC5DBSH User Manual download pdf (Page 26)

CHECKING THE WATER DISPENSER LINE

INSTALLATION OF THE WATER DISPENSER LINE

1) In order to operate the ice maker properly, water pressure of 20~125 psi(0.138~0.862 Mpa) is required.

In this range, a 6 oz paper cup can be filled in 10 secs.

2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.

3) If the refrigerator is installed in an area with low water pressure (below 20psi), you should install a boost-

er pump to compensate for the low pressure.

4) Ensure the water storage tank inside the refrigerator is filled. Push the water dispenser lever until the

water runs from the outlet.

- Slip the compression nut and plastic ferrule through the plastic tube.

- After inserting the sleeve, tighten the compression nut onto 1/4” com-

pression.

- Slip the compression ferrule and nut on copper(or plastic) tubing as

shown.

Tighten the comperssion nut onto the compression fitting(union).

- Turn the water on and check for any leakage.

• This water line installation is not warranted by the refrigerator or icemaker manufacturer. Follow these instruc-

tions carefully to minimize the risk of expensive water damage.

•

Banging pipes (water banging in the pipes) in house plumbing can cause damage to refrigerator parts and lead to water

leakage or flooding. Call a qualified plumber to correct the problem before installing the water supply line to the refrigerator.

• To prevent burns and product damage, do not hook up the water line to the hot water line.

•

If you use your refrigerator before connecting the water line, make sure the”Ice Type” is set to the ICE OFF position.

• Do not install the icemaker tubing in areas where temperatures fall below freezing.

• When using any electrical device (such as a power drill) during installation, be sure the device is insulated or

wired in a manner to prevent electric shock.

• All installations must be in accordance with local plumbing code requirements.

NOTE

A Water line installation kit is available at extra cost from your dealer.

Samsung recommends using a water supply kit containing copper tubing.

NOTE

Do not overtighten the compression nut.

NOTE

Waterline must be connected to drinkable water only

Before You Install the water line

Connect the water line to the refrigerator

- Shut off the main water supply line and turn the Ice maker

to the off position.

- Locate the nearest cold drinking water line.

- Follow the instructions in the ice maker installation kit.

Connecting to water supply line

1. Cold Water line

2. Pipe Clamp.

3.Copper (or Plastic) line

4.Compression Nut

5.Compression Sleeve

6.Shut Off Valve

7.Packing Nut.

Compression Nut

Ferrule

Sleeve

Compression fitting

Ferrule

Compression Nut

DA99-01473B(EN)-0.2 10/20/07 11:03 AM Page 26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Samsung RSC5DBSH User Manual Page 26

Comments to this Manuals

Related products and manuals for Fridges Samsung RSC5DBSH