Samsung GS25 User Manual download pdf (Page 20)

18_

GAS ADJUSTMENT

If the appliance is foreseen to operate with a type of gas different from the suitable supply gas, proceed as

follows: change the injectors, adjust the minimum flow of the burners, change the push-on connector.

In order to change the work top injectors, it is necessary to act as follows: remove the grids, remove

burners and flame-spreaders (fig. 10A), change the injector (fig. 10B) and replace it with another one

suitable for the new type of gas (see general injectors table in page 21). Re-assemble everything in the

opposite direction, paying attention to place the flame-spreader in the right way on the burner.

To change the oven injector, it is necessary to act as follows: open the oven door, remove the lower side

of the oven (fig. 10C), unscrew screw C and disassemble the oven burner (fig. 10D). Change the injector

(fig. 10E) and replace it with another one suitable for the new gas type (see table D).

Re-assemble everything in the opposite direction, paying attention to place the burner in the right way

on its rear slot.

To change the grill injector, it is necessary to act as follows: open the oven door, unscrew screw C and

disassemble the grill burner (fig. 10F / 10F1). Change the injector (fig. 10G) and replace it with another

one suitable for the new gas type (see general injectors table in page 21).

Re-assemble everything in the opposite direction, paying attention to place the burner in the right way

on its rear slot.

fig. 10A

fig. 10D

fig. 10F1 fig. 10Gfig. 10F

fig. 10B fig. 10C

fig. 10E

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

No comments

Samsung GS25 User Manual Page 20