Samsung WF10 User Manual download pdf (Page 75)

Chapter 5. Troubleshooting

Q I’m getting the ‘CMOS Checksum error’ message.

A This message may appear when the CMOS backup battery on the mother

board is dead. Refer to disassembling computer and replace the battery.

Then setup the BIOS Setup Utility accordingly.

Q My computer is booting up in Safe Mode

This message appears when there is an error in the Hard Drive connection

or BIOS Setup Utility. Please check these items.

What is the Safe Mode?

When your computer detects a problem while booting, it boots up with Windows

default settings. You may not be able to use certain functions in this mode.

A1 This may occur if Windows was not shut down properly.

You should use the start > Turn Off Computer menu to shut down your

computer.

A2 This may occur if system environment has not been recognized properly.

1. Boot up in the Safe Mode.

2. Run Check Disk as described in Chapter 3 Maintaining your computer.

3. Windows will run properly when you reboot your computer.

A3 Check for device errors.

1. Click start > Control Panel > Performance and Maintenance > System.

2. Click on Device Manger in the Hardware tab and reinstall the driver for

the device experiencing the error.

When turning your computer Off

Q My computer will not shut down.

A You may use the power button to shut your computer Off if it will not shut

down in Windows. However, you must press on the power button for more

than 4 seconds if the power button is setup for power save. Check Disk will

run automatically when you restart your computer after shutting down in this

manner.

computer WF10-5 3/7/02 5:18 PM Page 9

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 87 88

No comments

Samsung WF10 User Manual Page 75