Samsung SW-224BEA User Manual download pdf (Page 5)

Upgrading the Firmware Flash Memory

The product firmware can be upgraded by downloading the updated file from the

following Web site:

http://www.samsungodd.com

Before you install the CD-R/RW drive, we strongly recommend that you

check that your setup meets the system requirements listed below.

System Requirements

Item Description

Computer Intel Pentium II (or higher), 32 MB of RAM (or higher)

with an E-IDE interface

Disk space 700 MB minimum

Windows version Windows 95 / 98 OSR2 / 2000 / ME or XP /

Windows NT 4.0 (or higher)

Your CD-R/RW Drive

23 4

1. Connector for stereo headphones with a 3.6 mm stereo mini-jack

2. Headphone volume control

3. Emergency eject hole (if the compartment does not open when

you press the Eject button, power off the computer, insert a pin or

unfolded paper clip in the hole and push firmly)

4. Indicator light (when it is green, a disc is being read or recorded)

5. Disc compartment (the compartment opens and closes

automatically when you press the Eject button)

6. Eject button

1. Two-pin digital audio output terminal for use with a sound or MPEG

card supporting digital audio features

2. Four-pin sound output terminal for use with a sound card

(refer to the sound card documentation for further details)

3. Master/slave select terminal

4. 40pin host E-IDE interface connector

5. 4pin power terminal

General DMA Installation Guide

Windows 95/98/Me

Important!

Please read the entire DMA installation guide before installing your CD-R/RW drive.

About DMA Installation

For stable writing performance at high speeds, Installation of DMA transfer mode for

E-IDE/ATAPI interface is strongly recommended.

We recommend DMA mode for fast writing.

DMA Setting

Before you install your CD-R/RW drive, we recommend to set DMA to enabled on

your PC system. See the following procedure to set DMA transfer mode in windows

oprerating system. (Windows 95 OSR2/98/ME)

●

Click on START

●

Click on Settings

●

Select Control Panel

●

Select the System Icon

●

Select the Device Manager panel

in System Properties

●

Expand the CD-ROM icon

●

Select your CD-R/RW drive

●

Click on the Properties button

●

Click on the Settings tab

●

Check the DMA checkbox to enables DMA.

●

Click OK

●

Restart your PC

www.samsungelectronics.com

Windows 2000/XP

Select the DMA mode by selecting [Start > Setting > Control Panel > System >

Device Manager > IDEATA/ATAPI Controller > Default/Assistant IDE Channel

Advanced Information]

SW-224_eng-02 12/19/01 4:42 PM Page 4

1 2 3 4 5 6 7 8 9 10 ... 39 40

Comments to this Manuals

No comments

Samsung SW-224BEA User Manual Page 5

Comments to this Manuals

Related products and manuals for Storage Samsung SW-224BEA