7-72
Operation Manual
Tips!
Adding Reference Equation
If a reference appears in an equation, the following should be entered:
Equation
Enter a reference equation. Use the measurement calculator shown in the lower right corner.
Input Value Ranges
Enter the minimum (Low) and maximum (High) ranges for the selected reference.
Tolerance Information
Select the tolerance from w or d.
[Figure 7.43 User Equation]
View & Modify References
1. Under Selection, select a preset.
2. Press
and the Editor screen will appear.
3. View or edit the references.
EFW Sequential Measurement
NOTE: This setting is necessary when you set EFW Measure for User Key in Utility > Setup > User
Dened key > User Key Setup. Settings are applied when EFW is measured by pressing the User
button.
Congure the order of EFW measurements to be taken when the User button is pressed. Select
a measurement by using the trackball and the Set button, and change its position by using the
arrows.
Comments to this Manuals