Samsung DV218AGW/XAA User Manual download pdf

Service Mode:

This mode allows more detailed operation tests and trou-

bleshooting, to enter press Signal & Extra Rinse

simultaneously with the power on.

While in Service Mode the following tests can be per-

formed:

Quick Spin Test = Delay Start & Extra Rinse: This accel-

erates the drum motor from 0 to maximum RPM over a

few minutes. Note: Stay with the washer during this test,

out of balance detection is bypassed and the door may

not lock. Press the Start/Pause button during the test to hold

its spinning speed for 10 minutes before going back to Quick

Spin Test Mode.

Cycle Count = Press the Signal button to see how many

times the unit was used.

Soft Ware # = Press the Soil button to see the software ver-

sion information.

Fast Time Down = Start cycle then enter service mode.

Press the Temp button to advance to the next cycle.

Fault Code Test = Press the Spin button to view the stored

fault codes – then turn Jog Dial to view error codes (Push

Start/Pause while the code is displayed to view the cycle num-

ber when the error occurred).

Peripheral (Main PCB) input Tests; Select Extra Rinse

(display shows ln).

1. Water Temperature; Turn the Jog-Dial so that the Heavy

Duty LED is turned on. The Water Temperature will be dis-

played in Fahrenheit.

2. Door status; Turn the Jog-Dial so that the Permanent

Press LED is turned on. The door status will be displayed

(OP if open, CL if closed).

3. Door lock; Turn the Jog-Dial so that the Sanitize LED is

turned on. The door lock Switch status will be displayed (UL if

unlocked, Lo if locked).

4. Water Frequency; Turn the Jog-Dial so that the Bedding

LED is turned on. The Water Frequency will be displayed.

Quick Test Mode

Note: This test erases all faults and memory:

To enter press Soil, Signal, & Power simultaneously

with the power off.

1. All LED’s light up and the washer beeps as it en-

ters the Quick Test Mode.

2. The unit displays the software version for a

second then clears the EEprom. If EEEE is dis-

played the PCB ass’y is defective.

3. When the version is displayed, turn the Jog-Dial

CCW so that the version disappears. Each step of

the Jog-Dial displays the following; cycle count, wa-

ter level frequency, water temperature, EP condition,

test, spin, version.

Press the following keys to test the various compo-

nents.

Water valves: (lock the door first) Press Temp Key to

cycle in this order: Pre-Wash, Cold, Bleach, Cold &

Bleach, Hot & then off.

Door Lock/Unlock: Press Spin Key.

Circulation/Drain Pump: Press Signal Key.

Water heater: Press Soil Level Key.

Motor test: When either Test or Spin is displayed on

the LCD, press Start/Pause key.

Test mode: You can test the clockwise and counter-

clockwise movement of the motor. However, the water

level must satisfy the heater water level (24300) to enter

Test mode.

Spin mode: You can test the motor at a high rpm.

Fast Track Troubleshooting

Model:

WF511AB*

Publication # rsWF511 Revision Date 12/21/2011

IMPORTANT SAFETY NOTICE – “For Technicians Only” This service data sheet is

intended for use by persons having electrical, electronic, and mechanical experience

and knowledge at a level generally considered acceptable in the appliance repair trade.

Any attempt to repair a major appliance may result in personal injury and property

damage. The manufacturer or seller cannot be responsible, nor assume any liability for

injury or damage of any kind arising from the use of this data sheet.

EEPROM Clear Check

Power on. Press Delay Start, Signal and Power Key at

the same time. Good = Good Fail = FAiL

All memory will be cleared, including Fault Codes.

This should be done when the Main PCB is re-

placed.

WF511

12/21/2011

1 2 3 4 5 6 7

Summary of Contents

Page 1 - Fast Track Troubleshooting

Service Mode: This mode allows more detailed operation tests and trou-bleshooting, to enter press Signal & Extra Rinse s

Page 2 - 12/21/2011

WF51112/21/20112

Page 3

Washer Connector Checks WF520 CN1 1 Door Lock Close (Blk) 2 Door Lock Open (Wht) 3 Drain Pump (Vio) 4 NC 5 Bleach Valve (Pnk) 6 Bubble Pump (Gry) 7 P

Page 4

Door Unlock Check Test 1 Test 2 Connector CN6 Pin 2 (Gray) and RY1 Pin 1 (Blu) When Door is Unlocked there is a pulse of 120VAC for a few millisec-

Page 5

Error Type Error Mode Details LED LCD Drain Error nD 1 Che

Page 6

Laundry Touch Up Paints TOUCH UP PAINT, BLUE ONYX DH81-11980ATOUCH UP PAINT, IMPERIAL SILVER DH81-11981ATOUCH UP PAINT, NEAT WHITE DH81-11982ATOUCH UP

Page 7

Water valve connections for the Detergent Drawer When installing a washer and dryer on the first, or second floor, do not exceed this leg adjustment h

Comments to this Manuals

No comments

Samsung DV218AGW/XAA User Manual

Browse online or download User Manual for Electric laundry dryers Samsung DV218AGW/XAA. Fast Track Troubleshooting

Summary of Contents

Comments to this Manuals

Related products and manuals for Electric laundry dryers Samsung DV218AGW/XAA