Samsung RF197ACWP User Manual download pdf (Page 17)

INSTALLATION OF THE WATER LINE

Before You Install the water line

• Unplug the electric power to prevent electric shocks while installing the water supply line.

• The water line installation is not warranted by the refrigerator manufacturer.

So before you install the water line, read the whole steps for installing and follow these instructions

carefully to minimize the risk of expensive water damage.

• Banging pipes (water banging in the pipes) in house plumbing can cause damage to fridge parts and

lead to water leakage or ﬂooding. Call a qualiﬁed plumber to correct the problem before installing the

water supply line to the fridge.

• To prevent burns and product damage, do not hook up the water line to the hot water line.

• Do not install the water line in areas where temperatures fall below freezing.

• When using any electrical device (such as a power drill) during installation, be sure the device is

insulated or wired in a manner to prevent electric shock.

• All installations must be in a accordance with local plumbing code requirements.

• Use designated tubing.

• Cut the tubing, making sure the ends are square and clean.

• Water line must be connected to drinkable water only.

Important (cold water supply)

• For the ice maker to be operated properly,water pressure of 20~125psi is required.

• If cold water supply is under 20psi, purchase and install a booster pump to compensate for the low

water pressure or call your utility company.

• After initial installation, it may take up to two days for the ice maker try to ll with ice.

• If you turn the refrigerator on before the water line is connected, turn the ice maker off.

• See the user manual for further information.

Connecting to water supply line

• Shut off the main water supply line and turn the Ice

maker to the off position.

• Locate the nearest cold drinking water line.

• Follow the instructions in the water lter installation kit.

• After connecting the water supply line to the Cartridge

Holder inlet (insert plastic line in fully), install the Filter

Cartridge.

• Turn on water supply and Flush 3 gallons through lter

before use (ﬂush approximately 6 minutes)

• A compression tting and nut kit is supplied with the unit and it is inside the fridge drawer.

• If you want to install a water lter, it must be installed outside the refrigerator.

It is not provided with your new refrigerator. The ﬁlter cartridge and holder kit can be purchased

from the retailer where you purchased this refrigerator.Make sure you buy the SAMSUNG ﬁlter

cartridge (Replacement cartridge No : DA29-10105J) to ensure the best performance.

• Water line Kit and water lter are not covered by Samsung’s Warranty. The manufacturer (or dealer,

installer) of them is responsible for any defects and all the loss caused by water lter & water line

kit .

• The lter should be replaced according to manufacturer (or dealer)’s instruction.

• To order additional water lters, please contact the manufacturer (or dealer) of the lter.

• When pushing the Refrigerator back, make sure you don’t roll over the power cord or water

line(Icemaker supply line).

90 degree

1. Cold Water line

2. Pipe Clamp.

3. Plastic line

4. Compression Nut

5. Compression Sleeve

6. Packing Nut

7. Shut Off Valve

8. Filter Cartridge

9. Cartridge Holder

Using the water lter (not supplied)

Incorrect Correct

setting up _17

01 SETTING UP

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Comments to this Manuals

No comments

Samsung RF197ACWP User Manual Page 17

Comments to this Manuals

Related products and manuals for Fridges Samsung RF197ACWP