Samsung RF263BEAESP User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
18_ operating
check the
check the
water level
water level
Test button
Test button
Fridge button to set your desired temperature.
After a few seconds, the Fridge will begin
adjusting towards the newly set temperature. This
will be refl ected in the digital display.
- The temperature of the Freezer, Fridge
or Cool Select Pantry Zone may rise
when you open the doors too frequently,
or if a large amount of warm or hot food
is placed inside.
This may cause the digital display to blink. -
Once the Freezer and Fridge temperature
return to their normal set temperatures, the
blinking will stop.
If the blinking continues, you may need to -
“reset” the Refrigerator. Try unplugging the
appliance, wait for around 10 minutes and then
plug the power cord back in.
If there is a communication error between the -
Display and Main Controller, the Convertible
Display light may blink. If the blinking continues
for a long period of time, please contact a
Samsung Electronics Service Center.
USING THE COLD WATER
DISPENSER
Push the appropriate ice type
button to select what you want
dispensed.
Using the ice Dispenser
Place a glass underneath the ice
dispenser and push gently against the
dispenser lever with your glass.
Make sure the glass is in line with
the dispenser to prevent the ice from
bouncing out.
Please wait 2 seconds before removing the
glass under the dispenser to prevent spills.
If the Refrigerator door opens, the
Dispenser does not work.
When Cubed Ice is selected after using
the Crushed Ice mode, a small amount of
residual crushed ice might be produced.
Do not pull the lever out. You could damage
or break the lever’s spring.
To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and dry thoroughly it. Do
not use harsh or abrasive cleaners or solvents.
When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
The ice cubes generated by the rapid ice
making process will look white, which indicates
they are generated normally.
As the ice maker in the refrigerator room
makes ice cubes even faster, move the ice
cubes from the refrigerator ice bin to the
freezer ice bin if you need more ice cubes.
(only for RF263TE***)
If ice doesn’t come out, pull out the ice bucket
and press the test button located on the right
side of ice maker.
Do not press the test button continuously
when the tray is fi lled with ice or water. Water
may overfl ow or ice may jam the bucket.
Normal Use
To fi ll the ice bucket to maximum capacity after
installation, follow these steps:
Water may overfl ow or ice may jam the bucket.
CAUTION
CAUTION
CAUTION
NO ICE
NO ICE
Select this if you want to
Select this if you want to
turn ice maker off
turn ice maker off
Recommend Temp (Fridge) : 37 °F (or 3 °C )
Recommend Temp (Fridge) : 37 °F (or 3 °C )
DA68-02615D(0.0).indb 18DA68-02615D(0.0).indb 18 2012.7.11 8:16:33 PM2012.7.11 8:16:33 PM
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 79 80

Comments to this Manuals

No comments