Samsung RF4267HARS User Manual download pdf (Page 10)

10_ setting up

CHECKING THE WATER DISPENSER LINE

A water dispenser with a filter is one of the helpful

features on your new refrigerator. To help promote

better health, the water filter removes unwanted

particles from your water. However, it does not sterilize

or destroy microorganisms. You may need to purchase

a water purifying system to do that.

In order for the ice maker to operate properly, a water

pressure of 20~125 psi (138~862 kPa) is required.

Under normal conditions, a 170 cc (5.75 oz.) cup can

be filled in about 10 seconds.

If the refrigerator is installed in an area with low water

pressure (below 20psi), you can install a booster pump

to compensate for the low pressure.

After you have connected the water line, make

sure the water storage tank inside the refrigerator is

properly filled. To do this, press the water dispenser

lever until the water runs from the water outlet.

Water line installation kits are available at extra

cost from your dealer. We recommend using a

water line installation kit that contains copper tubing

and ¼” compression nut.

Connecting to the water supply line

1. First, shut off the main water

supply.

2. Locate the

nearest cold

water drinking

line and install

the pipe clamp

and shut off

valve.

3. Connect the water line installation kit to the shut

off valve.

INSTALLING THE WATER LINE

Connecting the water supply line to the

refrigerator.

There are several items that you need to purchase

to complete this connection.

You may find these items sold as a kit at your local

hardware store.

1. Connect the household water line to the

assembled compression fitting.

- If you are using copper tubing, slip the

compression nut ( B )

(not supplied) and ferrule

(not supplied) on the copper tubing (not supplied)

as shown.

- If you are using plastic tubing ( B ) , insert the

molded end (Bulb) of the plastic tubing ( B ) into

the compression fitting.

Do not use without the molded end (Bulb) of

the plastic tubing ( B ).

2. Tighten the compression nut ( B ) onto the

compression fitting.

Do not over-tighten the compression nut ( B ) .

Pipe clamp

Cold water line

Shut off valve

Pipe clamp

Cold water line

Water line installation kit

Compression

Nut (1/4”)

(Assembled)

Ferrule

(Not supplied)

Plastic Tubing

(Assembled)

Compression Fitting

(Assembled)

Molded end(Bulb)

Compression nut (B)

(1/4”)

(Not supplied)

Copper tubing

(Not supplied)

Plastic tubing (B)

(Not supplied)

Household water supply line

Refrigerator

Use Copper Tubing Use Plastic Tubing

• ¼” copper tubing

• ¼” compression nut (1pc)

• Ferrule (2pc)

• ¼” plastic tubing

→

Molded end(Bulb)

• ¼” compression nut (1pc)

CAUTION

DA68-02481A-11.indb 10 13. 12. 4. �� 3:34

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 83 84

Comments to this Manuals

No comments

Samsung RF4267HARS User Manual Page 10

Comments to this Manuals

Related products and manuals for Fridges Samsung RF4267HARS