setting up _15
01 SETTING UP
REMOVING THE
REFRIGERATOR DOORS
Some installations require door/drawer removal to
transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed.
Before removing the door/drawer make sure you
read following items.
Disconnect power to the Refrigerator before
removing the door or drawer.
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
RequiredTools(Notprovided)
Disassembling the fridge door
Be careful not to drop and scratch the fridge door while removing the fridge door!
1. Remove the 3 screws
holding down the top table
and remove it.
2. Disconnect electric wire on
the top of the refrigerator.
3. Remove the 3 hex bolts
that hold the hinge on the
top of the refrigerator with
the 10mm socket wrench.
4. Remove the screw that
holds the ground wire with
a philips screwdriver(+).
5. Separate the hinge from
the electric wire and
ground wire as shown
above.
6. Lift the door straight up to
remove. Be careful not to
drop and scratch the doors
while removing them.
Phillips Head
Driver(+)
Flat Head Driver(-) Socket Wrench
(10mm) (for bolts)
Hex Wrench
(Ø5mm)
(for Mid hinge)
Hex wrench
(5/32 inch)
(for Mid hinge
shaft)
CAUTION
WARNING
Top Table
Socket wrench
Comments to this Manuals