Samsung COMBO DRIVE SM-316 User Manual download pdf (Page 4)

ENGLISH

Installing the COMBO Drive

Connecting the Cables

To install your COMBO drive in the PC, proceed as follows.

Make sure that the PC is powered off and disconnected from any power source.

Connecting the power cable

The 4-pin power cable from the internal power unit of your computer must be

connected to the power terminal on the rear of the COMBO drive.

Note:An improperly connected power cable may cause trouble. Check the direction of

the power connector and the incline side of the COMBO drive before connecting.

Cut side

Connecting the IDE cable

Insert the IDE cable (40-pin), which is connected to the hard disk to the interface

terminal. (Place the red line of the cable close to the Pin 1.)

Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at

the rear of the COMBO drive.

When using one E-IDE cable

When using two E-IDE cable

If necessary, attach a horizontal bracket to

both sides of the drive.

Use of the brackets depends on your computer model;

you can purchase these accessories separately from

your computer dealer.

Remove the cover from a free expansion slot

and install the COMBO drive,

as shown in the illustration.

If you have no free expansion slot,

install the drive in place of the

diskette drive.

Power cable

E-IDE cable

Master/slave select terminal

Audio cable

Pin 1

Key Slot

Red Line

HDD

Slave Drive (Choose the SL Jumper)

Motherboard

COMBO Drive

cover

If there is only one COMBO drive, select MA (Master).

HDD

Master Drive (Choose the MA Jumper)

Slave Drive (Choose the SL Jumper)

SEC 1

PRI1

Motherboard

If there is two COMBO drive, select MA (Master) / SL (Slave).

HDD

(Choose the MA jumper) (Choose the SL jumper)

SEC 1

PRI1

Motherboard

+12V DC

Ground

+5V DC

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Samsung COMBO DRIVE SM-316 User Manual Page 4

Comments to this Manuals

Related products and manuals for Hardware Samsung COMBO DRIVE SM-316