English - 21
OPERATING
(6) Ice Type
Touch the Ice Type button to change the
ice type.
Each time you touch the Ice Type button,
the cubed and crushed ice modes
alternate and the Cubed or Crushed ice
icon lights up, indicating your selection.
If you don’t need ice, turn the function o
to save on water and energy consumption.
(See Ice Maker O below.)
Lighting
Touch and hold the Cubed button for three
seconds to set the Dispenser LED lamp
(under the display) to continuous mode so
that it stays on continuously.
If you want the Dispenser lamp to come on
only when some one uses the dispenser,
touch and hold this button for 3 seconds
again to turn the continuous mode o.
(7) Ice Maker O (Hold 3sec)
Touch the Ice Maker O button for
3seconds until the Ice Maker O Indicator
( ) illuminates.
(8) Filter
Water filter usage
This icon lights when you need to change
the filter, usually after the refrigerator has
dispensed about 300 gallons of water (after
about 6 months).
After you install the new water filter, touch
and hold the Crushed Ice button for
3Seconds to reset the filter.
- If water is not dispensing or dispensing
slowly, you need to replace the water
filter because the water filter is clogged.
- Some areas have large amounts of lime
in their water, which causes the water
filter to clog more quickly.
Exhibition Mode
CAUTION
• Exhibition Mode is designed for use by retailers
when they are displaying refrigerators on the
shop floor.
In Exhibition Mode, the refrigerator’s fan motor
and lights work normally, but the compressors
do not run, and the refrigerator and freezer
do not get cold. To start Exhibition Mode,
touch and hold the Freezer, Fridge, and Door
Alarm buttons at the same time for 5 seconds
during normal operation. The refrigerator chime
sounds.
To cancel Exhibition Mode, touch and hold the
Freezer, Fridge, and Door Alarm buttons at the
same time again for 5 seconds. The refrigerator
chime sounds once more.
DA68-03194D-00.indb 21 14. 12. 18. �� 9:41
Comments to this Manuals