Samsung ROSSO-W User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
18_ operating
5. Press the “Ice Off / Hold 3 Sec for Filter
Reset” button for about 3 seconds to reset the
water filter. The color of indicator changes from
red to light off.
A newly installed water fi lter cartridge may
cause water to briefl y spurt from the water
dispenser. This is due to air getting into the
line. It should pose no problem to operation.
Removing residual matter inside the
water supply line after installing a
new fi lter
1. Press the Water button, and then push the
Dispenser Lever with a cup or glass.
2. Flush 1 gallon of water through the filter, one
cup or glass at a time. (Flush approximately 6
minutes.) This will clean the water supply system
and remove air from the lines.
- Additional flushing may be required in some
households.
3. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be
a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace the
filter if necessary.
Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure, call
a licensed, qualifi ed plumber.
Ordering replacement fi lters
To order more water fi lter cartridges, contact your
authorized Samsung dealer.
CHANGING THE WATER FILTER
To reduce risk of water damage to your
property DO NOT use generic brands of
water fi lers in your SAMSUNG Refrigerator.
USE ONLY SAMSUNG BRAND WATER
FILTERS.
SAMSUNG is not legally responsible for any
damage, including, but not limited to property
damage caused by water leakage from the use of a
generic water fi lter.
SAMSUNG Refrigerators are designed to work
ONLY WITH SAMSUNG Water Filters.
If you want to purchase any accessories, please
contact with Samsung service center.
The “Filter Indicator” light lets you know when it is
time to change your water fi lter cartridge. To give
you preparation time to get a new fi lter, the red light
will come on just before the capacity of the current
lter runs out. Changing the fi lter on time provides
you with the freshest, cleanest water from your
fridge.
To change the water fi lter, follow these steps:
1. Turn the water filter 90˚
counter-clockwise.
2. Pull the water filter from
the filter housing.
3. Insert new water filter
inside the filter housing.
4. Turn the new water filter
90˚ clockwise.
WARNING
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments