Samsung SRF936CLS User Manual download pdf (Page 20)

20_ setting up

HOW TO ADJUST THE DOOR

HEIGHT

If any one of the doors is lower than

the other:

• Check if the Refrigerator is level

before adjusting the door.

• Adjust the door height difference

by inserting a Snap Ring (

1

) as

shown between the door and the

hinge. You can use the rings on the right side

door of the fresh food compartment and both

sides of the freezer compartment.

• After checking the height difference, select one

Snap Ring with a suitable thickness. Insert one

Snap Ring only, Inserting two or more Snap

Rings may cause the Snap Rings to slip out or

make a rubbing noise.

• Lift up the lower door and insert the Snap

Ring into the space between the Door and the

Hinge.

• To avoid injury, insert or remove Snap

Rings carefully.

• Keep the Snap Rings out of the reach of

children and make sure that children do

not play with them or put them into their

mouths.

• 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap

Rings come with the Refrigerator.

• If the Refrigerator is level before you

load it with food, the Refrigerator may

become unbalanced due to the weight

of the food. If this occurs, adjust the level

again using the same procedure.

• If you raise the door too far, it can rub

against the Top Cover.

Snap Rings included with the refrigerator:

1mm 1.5mm 2mm 2.5mm

1

CAUTION

HOW TO ADJUST THE DOOR GAP

If the gap between the left and right fridge

compartment doors is not even.

• You can adjust the gap by turning

the bolt at the top right of the cold

storage compartment door.

• Do not turn the bolt too far. You

can break it.

1. With the doors closed, remove the 3 screws

holding the top cover using a Phillips

screwdriver, and then lift it off together with the

connected cables.

2. Turn the bolt with a 4 mm

hexagonal L-wrench to adjust

the gap. (Not provided)

3. Turn the bolt clockwise to ( ) widen the gap.

Turn the bolt counter clockwise ( ) to narrow

the gap.

DA68-02836F-06.indd 20 14. 8. 6. �� 7:47

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments