Samsung DV42H5000EW/A3 User Manual download pdf (Page 19)

English - 19

02 INSTALLATION

Connecting the inlet hose (Steam model only)

The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.

1. Turn the cold water faucet oﬀ.

2. Attach the brass female end of the Y connector (A) to the cold water

faucet.

3. Attach the straight end of long hose (B) to the Y connector.

4. Using pliers, tighten the coupling with an additional two-thirds turn.

If the Y connector cannot be attached directly to the cold water

faucet, the short hose must be used.

(If space permits, please skip steps 5 to 8, and go directly to step 9.)

5. Attach the short inlet hose (C) to the cold water faucet.

Screw on the coupling by hand until it is seated on the faucet.

6. Using the pliers, tighten the coupling with an additional two-thirds

turn.

7. Attach the Y connector (A) to the brass male end of the small hose.

Screw on the coupling by hand until it is seated on the connector.

8. Using the pliers, tighten the coupling with an additional two-thirds

turn.

9. Attach the angled end of long hoses to the ﬁll valve at the bottom of

the dryer rear frame. Screw on the coupling by hand until it is seated

on the ﬁll valve connector.

10. Using pliers, tighten the coupling with an additional two-thirds turn.

11. Attach the washer hose (D) to the other side of the Y connector (A).

Screw on the hose coupling until it is tight. Using pliers, tighten the

coupling with an additional two thirds turn.

12. Check that the water faucets are on.

13. Check for leaks around the Y connector, faucets and hoses.

When you tighten the coupling with pliers, do not overtighten. This may damage the coupling.

DV5000H_DC68-03381A-11_EN.indd 19 2018-06-26  2:34:49

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 139 140

No comments

Samsung DV42H5000EW/A3 User Manual Page 19