Samsung ML-1640/XSA User's Guide download pdf (Page 15)

15 _Getting started

getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:

• Setting up the hardware

• Printing a demo page

• System requirements

• Installing the software

SETTING UP THE HARDWARE

This section shows the steps to set up the hardware which is explained in

the Quick Install Guide. Make sure you read Quick Install Guide and

complete the following steps.

1. Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow

extra space to open covers and trays.

The area should be well-ventilated and away from direct sunlight or

sources of heat, cold, and humidity. Do not set the machine close to the

edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the

altitude setting to optimize your printing. Place the machine on a flat and

stable surface, not letting it lean more than 2 mm (0.08 inches).

Otherwise, it may affect the printing quality.

2. Unpack the machine and check all the enclosed items.

3. Remove the tape holding the machine tightly.

4. Install all four of the toner cartridge.

5. Load paper. (See "Loading paper" on page 21.)

6. Make sure that all the cables are connected to the machine.

7. Turn the machine on.

PRINTING A DEMO PAGE

Print a demo page to make sure that the machine is operating correctly.

To print a demo page:

In ready mode, press and hold the Cancel button for about 2 seconds.

When you move the machine, do not tilt or turn it upside down.

Otherwise, the inside of the machine may be contaminated by toner,

which can cause damage to the machine or bad print quality.

This equipment will be inoperable when mains power fails.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 82 83

No comments

Samsung ML-1640/XSA User's Guide Page 15