
To create a new Network Profile, use the following
parameters:
•
Set Name
: Profile name.
•
Access name
: Access point name.
•
Auth type
: Type of authentication used for this WAP connection:
None, Normal, or Secure.
•
User ID
: User ID required to connect to the network.
•
Password
: User password required to connect to the network.
•
Protocol
: Connection protocol used by the WAP browser: WAP,
HTTP, or Other.
•
Home URL
: URL address of the page to use as your homepage.
•
Gateway Address
(WAP only): Gateway Address, which only
appears when the Protocol is set to WAP.
•
Secure connection
(WAP only): Select On or Off depending on
whether you have a secure connection. This option only appears
when the Protocol is set to WAP.
•
Proxy Address
(HTTP only): Set the proxy server address.
•
Linger Time (sec.)
: Time period (in seconds) after which the
network is disconnected if there is no new data traffic.
•
Advanced
: Configure some of the IP-specific information: Static
IP, Static DNS, Server information, and Traffic Class. Highlight this
option and press
Edit
to access the following options:
–
Static IP
: Specify if you want to manually enter an IP address.
Remove the check mark if you want the server to automatically
assign the IP address.
–
Local phone IP
: Configure the local phone IP address.
–
Static DNS
: Specify if you want to manually enter the Domain
Name Server (DNS) address. Remove the check mark if you
want the server to automatically assign the address.
–
Server 1/Server 2
: The Domain Name Server (DNS) addresses.
–
Traffic class
: Select the traffic class, press
Edit
, select a Traffic
Class (Subscribed, Conversation, Streaming, Interactive, or
Background) and press
OK
.
Note:
The WAP settings may vary depending on the service
provider.
Changing Your Settings 138
Comments to this Manuals