Samsung PT60A User Manual download pdf (Page 133)

5-11

Chapter 5 Measurements and Calculations

Tips!

Repositioning Point

You may drag and drop the start point or the end point to change their position after the distance

has been measured. You can only reposition the start/end point of the last measurement taken,

which is shown in green on the screen.

Tips!

Finishing Measurement

You can ﬁnish taking measurements by performing one of the following actions. In Calculation, the

measurement result will only be recorded when measurement is complete. Measurement data will

not be recorded in the report except for in the circumstances described below. This action applies

to all measurement items.

1. After taking a measurement, tap the touch screen twice in quick succession.

2. After taking a measurement, tap the Freeze button.

3. After taking a measurement, tap the Report button.

4. After taking a measurement, select another menu.

When measuring is complete, the measurement markers on the screen will turn from green to

yellow, and the measurement results will turn white.

Once a measurement has been completed, you cannot reposition its start or end point.

 Angle

A basic measurement that is available in all diagnosis modes. Specify two straight lines in a 2D image

and measure the angle between them.

1. Select Angle from the touch screen’s soft menu. On the touch screen, draw a straight line in the

area to measure the angle. Refer to ‘Distance’ for instructions on drawing a straight line.

2. A straight line that meets the straight line you have drawn at an angle will be automatically

generated on the screen.

3. Drag and drop the point on the automatically generated line to adjust the angle.

4. The angle between two lines will be calculated and displayed on the screen.

X

when two angles are calculated, the smaller angle is displayed.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 235 236

No comments

Samsung PT60A User Manual Page 133