25
1. Introduction
Turning on the machine
1
Connect the machine to the electricity supply first.
Turn the switch on if the machine has a power switch.
Illustrations on this user’s guide may differ from your machine depending
on its options or models. Check your machine type (see "Front view" on
page 16).
2
Power is turned on automatically.
For M207x series, press (Power/Wakeup) button on the control
panel.
If you want to turn the power off, press and hold (Power/Wakeup)
button for about 3 seconds.
26
1. Introduction
Installing the driver locally
A locally connected machine is a machine directly attached to your computer using the cable. If your machine is attached to a network, skip the following steps below
and go on to installing a network connected machine’s driver (see "Installing driver over the network" on page 136).
• If you are a Mac or Linux operating systems user, refer to the "Installation for Mac" on page 127 or "Installation for Linux" on page 129.
• The installation window in this User’s Guide may differ depending on the machine and interface in use.
• Only use a USB cable no longer than 3 meters (118 inches).
14
Windows
1
Insert the supplied software CD into your CD-ROM drive.
If the installation window does not appear, click Start > All programs > Accessories > Run.
X:\Setup.exe replacing “X” with the letter, which represents your CD-ROM drive and click OK.
2
Review and accept the installation agreements in the installation window. Then, click Next.
3
Select USB connection on the Printer Connection Type screen. Then, click Next.
4
Follow the instructions in the installation window.
Comments to this Manuals