Samsung RF28HDEDBSG/AA Owner's Manual download pdf (Page 23)

English - 23

OPERATING

Removing any residual matter inside the

water supply line after installing the water

ﬁlter.

1. Turn ON the water supply if you turned it off

when you installed the water ﬁlter.

2. Run water through the dispenser until the water

runs clear (approx. 6 to 7 minutes).

This will clean the water supply system and

remove air from the lines.

3. Additional ﬂushing may be required in some

households.

4. Open the Refrigerator door and make sure

there are no water leaks coming from the water

ﬁlter.

Be sure to ﬂush the dispenser thoroughly,

otherwise water may drip from the

dispenser.

This means that there is still air in the line.

Reverse Osmosis Water Supply

IMPORTANT:

The pressure of the water supply coming out of a

reverse osmosis system going to the water inlet

valve of the refrigerator needs to be between 35

and 120psi. (241 and 827kPa)

If a reverse osmosis water ﬁltration system is

connected to your cold water supply, the water

pressure to the reverse osmosis system needs to

be a minimum of 40 to 60psi. (276 to 414kPa)

If the water pressure to the reverse osmosis

system is less than 40 to 60psi (276 to 414kPa):

• Check if the sediment ﬁlter in the reverse

osmosis system is blocked.

Replace the ﬁlter if necessary.

• Allow the storage tank on the reverse osmosis

system to reﬁll after heavy usage.

• If your refrigerator has a water ﬁlter, it may

further reduce the water pressure when used

in conjunction with a reverse osmosis system.

Remove the water ﬁlter.

If you have questions about your water pressure,

call a licensed, qualiﬁed plumber.

DA68-03029A-01.indb 23 2014. 3. 19. �� 9:24

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 127 128

Comments to this Manuals

No comments

Samsung RF28HDEDBSG/AA Owner's Manual Page 23

Comments to this Manuals

Related products and manuals for Fridges Samsung RF28HDEDBSG/AA