Samsung MC26AC2X Service Manual download pdf (Page 14)

Operating Instructions and Installation

3-7Samsung Electronics

3-2-2(c) Connecting the Assembly Cable.

1 2 E3

(L)

(N)

COM

2 E3

Indoor

unit

Outdoor

unit

Earth

terminal

Earth terminal

The outdoor unit is powered from the indoor unit via the assembly

cable. If the outdoor unit is more than five metres away from the

indoor unit, the cable must first be extended to a maximum of ten

metres.

1. Extend the assembly cable if necessary.

2. Open the front grille by pulling on the tabs on the lower right

and left sides of the indoor unit.

3. Remove the screw securing the connector cover.

4. Pass the assembly cable through the rear of the indoor unit and

connect the assembly cable to terminals N1 to 1.

• Each wire is labelled with the corresponding terminal

number.

5. Firmly fix the ass’y cable with clamp wire holder.

6. Pass the other end of the cable through the 65mm hole in the

wall.

7. Replace the connector cover, carefully tightening the screw.

8. Close the front grille.

9. For further details on how to plug the other end of the assem-

bly cable into the outdoor unit, refer to page 3-8.

3-2-2(d) Installing and Connecting the Indoor Unit Drain Hose

Care must be taken when installing the drain hose for the indoor unit to ensure that any conden-

sation water is correctly drained outside. When passing the drain hose through the 65mm hole

drilled in the wall, check that none of the following situations occur.

To install the drain hose, proceed as follows.

1. If necessary, connect the 2-metre extension to the drain hose.

2. If you are using the extension, insulate the inside part of the extension drain hose with a

shield.

3. Pass the drain hose under the refrigerant piping, taking care to keep the drain hose tight.

4. Pass the drain hose through the hole in the wall, making sure that it is sloping downwards, as

shown in the illustrations above.

The hose must

NOT slope upwards.

The hose will be fixed permanently into position once

the whole installation has been tested for gas leaks;

The end of the drain

hose must NOT be

placed in water.

Do NOT bend the

hose in different

directions.

Keep a clearance of at

least 5cm between the

end of the hose and the

ground.

Do NOT place the end

of the drain hose in a

hollow.

Shield

Drain hose Extension drain hose

5cm

less

DB98_11868A(1)_1 3/3/03 11:17 AM Page 2-11

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

Comments to this Manuals

No comments

Samsung MC26AC2X Service Manual Page 14

Comments to this Manuals

Related products and manuals for Split-system air conditioners Samsung MC26AC2X