Samsung RF23M8090SR/AA Owner's Manual download pdf (Page 63)

English 63

Maintenance

3. Insert a new lter cartridge. Use only

Samsung-provided or approved lters.

4. Turn the cartridge knob clockwise to

lock into place.

5. Press and hold Filter Reset on the main

panel for 3 seconds to reset the life

cycle detector. The Filter Reset indicator

(

) turns off.

6. When you are done replacing the lter,

open the water valve and run water

through the dispenser for about 7

minutes. This is to remove impurities

and air from the water line.

NOTE

• A newly installed lter may cause the water dispenser to spurt water briey. This is

because air has entered the waterline.

• The replacement process may cause the water dispenser to drip for a short period of

time. If it drips, simply wipe up any water on the oor with a dry towel.

Reverse osmosis water ltration system

The water pressure of the water supply system to a reverse osmosis water ltration

system must be between 35 psi and 120 psi (241 kPa and 827 kPa).

The water pressure of the reverse osmosis water ltration system to the refrigerator’s

cold water line must be at least 40 psi (276 kPa). If the water pressure is below these

specications:

• Check if the sediment lter in the reverse osmosis system is blocked. Replace the lter

if necessary.

• Rell the water tank in the reverse osmosis system with water.

• If your refrigerator has a water lter, it may further reduce the water pressure when

used in conjunction with a reverse osmosis system. Remove the water lter.

For more information or servicing, contact a licensed plumbing professional.

Untitled-1 63 2017-01-16  4:52:59

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 231 232

No comments

Samsung RF23M8090SR/AA Owner's Manual Page 63