Samsung A727 - SGH Cell Phone 28 MB User Manual download pdf (Page 54)

CAPTURING DATA

CellDEK® User Manual 54

Many Cell Phones and PDA’s have a built-in

infrared (IR) port, which can be used to transfer

data from the target device.

1. Select Infrared from the Connectivity Option

Screen and tap the “Run Extraction” button.

2. A prompt will appear on the screen asking the

user to set the target device to infrared. If the

device is a recognized cell phone, CellDEK will

display instructions to set it to infrared mode.

Figure 41 – Instructions for Infrared Mode

NOTE: Most Windows-based PDA’s are set to

IR mode by going to Start – Active Sync™ -

Tools – Infrared (IR) Connection.

3. Once the device is in infrared mode, place it

next to the Infrared emitter on the control panel.

Make sure that the device’s IR port is facing the

emitter.

4. After 5 – 20 seconds, the CellDEK will emit a

tone to indicate that the IR connection has been

made.

Bluetooth Connection (Cell Phones)

Many Cell Phones have Bluetooth capability, which

can be used to transfer data from the target device.

CellDEK has a range of 60 feet for Bluetooth

connectivity.

Bluetooth extraction is a wireless communication

link. On initiation, CellDEK will produce a list of all

Bluetooth enabled devices. Caution is therefore

required when selecting the correct device name

list, particularly if two devices in the area have the

same name. Any connection will require

confirmation/acceptance on the handset in question

before the extraction process can commence. This

prevents accidental connection to other devices.

Bluetooth capability can only extract data once the

handset has been 'paired' with the CellDEK

unit. Pairing is when you enter a 4-digit code into

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 213 214

No comments

Samsung A727 - SGH Cell Phone 28 MB User Manual Page 54