Samsung YP-P10 User Manual Page 361

  • Download
  • Add to my manuals
  • Print
  • Page
    / 596
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 360
USB DEVICE S3C2440A RISC MICROPROCESSOR
13-6
POWER MANAGEMENT REGISTER (PWR_REG)
This register acts as a power control register in the USB block.
Register Address R/W Description Reset Value
PWR_REG 0x52000144(L)
0x52000147(B)
R/W
(byte)
Power management register 0x00
PWR_ADDR Bit MCU USB Description Initial State
Reserved [7:4]
USB_RESET [3] R SET Set by the USB if reset signaling is received
from the host. This bit remains set as long as
reset signaling persists on the bus
0
MCU_RESUME [2] R/W R
/CLEAR
Set by the MCU for MCU Resume.
The USB generates the resume signaling during
10ms, if this bit is set in suspend mode.
SUSPEND_MODE [1] R SET
/CLEAR
Set by USB automatically when the device
enter into suspend mode.
It is cleared under the following conditions:
1) The MCU clears the MCU_RESUME bit by
writing ‘0’, in order to end remote resume
signaling.
2) The resume signal from host is received.
0
SUSPEND_EN [0] R/W R Suspend mode enable control bit
0 = Disable (default).
The device will not enter suspend mode.
1 = Enable suspend mode
0
Page view 360
1 2 ... 356 357 358 359 360 361 362 363 364 365 366 ... 595 596

Comments to this Manuals

No comments