Samsung YP-P10 User Manual download pdf (Page 403)

100

101

LCD CONTROLLER S3C2440A RISC MICROPROCESSOR

15-8

Display Types

The LCD controller supports 3 types of LCD drivers: 4-bit dual scan, 4-bit single scan, and 8-bit single scan display

mode. Figure 15-2 shows these 3 different display types for monochrome displays, and Figure 15-3 show these 3

different display types for color displays.

4-bit Dual Scan Display Type

A 4-bit dual scan display uses 8 parallel data lines to shift data to both the upper and lower halves of the display at

the same time. The 4 bits of data in the 8 parallel data lines are shifted to the upper half and 4 bits of data is shifted

to the lower half, as shown in Figure 15-2. The end of frame is reached when each half of the display has been

shifted and transferred. The 8 pins (VD[7:0]) for the LCD output from the LCD controller can be directly connected to

the LCD driver.

4-bit Single Scan Display Type

A 4-bit single scan display uses 4 parallel data lines to shift data to successive single horizontal lines of the display

at a time, until the entire frame has been shifted and transferred. The 4 pins (VD[3:0]) for the LCD output from the

LCD controller can be directly connected to the LCD driver, and the 4 pins (VD[7:4]) for the LCD output are not used.

8-bit Single Scan Display Type

An 8-bit single scan display uses 8 parallel data lines to shift data to successive single horizontal lines of the display

at a time, until the entire frame has been shifted and transferred. The 8 pins (VD[7:0]) for the LCD output from the

LCD controller can be directly connected to the LCD driver.

256 Color Displays

Color displays require 3 bits (Red, Green, and Blue) of image data per pixel, so the number of horizontal shift

registers for each horizontal line corresponds to three times the number of pixels of one horizontal line. These results

in a horizontal shift register of length 3 times the number of pixels per horizontal line. This RGB is shifted to the LCD

driver as consecutive bits via the parallel data lines. Figure 15-3 shows the RGB and order of the pixels in the parallel

data lines for the 3 types of color displays.

4096 Color Displays

Color displays require 3 bits (Red, Green, and Blue) of image data per pixel, and so the number of horizontal shift

registers for each horizontal line corresponds to three times the number of pixels of one horizontal line. This RGB is

shifted to the LCD driver as consecutive bits via the parallel data lines. This RGB order is determined by the

sequence of video data in video buffers.

1 2 ... 398 399 400 401 402 403 404 405 406 407 408 ... 595 596

Comments to this Manuals

No comments

Samsung YP-P10 User Manual Page 403

Comments to this Manuals

Related products and manuals for MP3/MP4 players Samsung YP-P10